J'ai postulé en ligne. Le processus a pris 4 semaines. J'ai passé un entretien chez Apple (Cupertino, CA) en janv. 2016
Entretien
Everyone I interacted with was very friendly; the interviews tested a variety of mechanical engineering skills from your run of the mill beam bending problems to very specific product design terminology. It did not become evident until the final interview that they were looking for a high level of experience with materials and small-scale manufacturing.
Questions d'entretien [1]
Question 1
Identify the smallest tolerance loop for this mechanism design.
The interview went well overall. The interviewer opened with a discussion about a project I'm proud of, then a beam scenario question that covered structural and load analysis, stress and deflection, and material selection — testing my ability to connect first-principles thinking across the full problem space.
J'ai postulé via un établissement d'enseignement supérieur ou universitaire. J'ai passé un entretien chez Apple (Cupertino, CA) en avr. 2026
Entretien
Interview with hiring manager then virtual onsite. They ask you general mechanical engineering questions as well as questions dependent on type of team and skills they are looking for. Not bad overall just brush up on basic beam deflection, GD&T, Design analysis etc.
They gave me a take home tolerance analysis worksheet. It was essentially a tolerance stack up for one of their products and felt fairly straight forward. Thought I answered it well but ultimately they decided to move forward with other candidates.