J'ai postulé via un établissement d'enseignement supérieur ou universitaire. J'ai passé un entretien chez Texas Instruments (Bengaluru) en sept. 2021
Entretien
The interviewer was very friendly. About 50 students were shortlisted for interview from the screening test held on HirePro. The screening test had 3 sections: Aptitude, Analog and Digital, 30, 20, 20 was the question division. I got selected in screening and next was interview round. The interview was conducted in 6 panels with 8 students in each panel.
Questions d'entretien [1]
Question 1
The interviewer started with basic step response of low pass RC circuits. Then went on adding resistors and capacitors to the circuit. Then he told me to analyse an opamp circuit with step input. Then he went to bode plot of a first order transfer function. He asked why the transfer function does not blow up at a pole in the bode plot.
J'ai passé un entretien chez Texas Instruments (Dallas, TX)
Entretien
Had two Zoom interviews. Each interview is 45 minutes.
The first interview was by 2 people from random locations. The second interview was by 2 people from the team I would join.
J'ai postulé via un établissement d'enseignement supérieur ou universitaire. Le processus a pris 1 semaine. J'ai passé un entretien chez Texas Instruments (Hyderâbâd) en juil. 2024
Entretien
It is in campus drive
First round is test of aptitude and analog each having 20 questions for 30 min and 45 minutes respectively.
Second round is technical interview of 45 min to 1hour duration.
After this round shortlisted candidates were announced.
Questions d'entretien [1]
Question 1
2 basic questions on network analysis - one on charging and of capacitor and graph of current and voltage.
Second on iv characteristics
About projects
Some basics of op amp , network
J'ai postulé via une autre source. Le processus a pris 1 semaine. J'ai passé un entretien chez Texas Instruments (Bengaluru) en mai 2024
Entretien
Interview was initially about the circuit used for Analog Hardware design contest. Was asked to draw the circuit which i used in the contest. From that a particular part of the circuit was asked in more detail. Also asked about signal processing - aliasing.
Questions d'entretien [1]
Question 1
1. Circuit used for circuit design contest (ppg sensor module)
2. Opamps
3. Nyquist sampling - aliasing
4. FFT